GRAPHTEC CUTTING PRO FC3100-60 Service Manual page 70

(4) When securing the Y FPC cable with fixing tape as shown in Fig.4-77, face the Y FPC cable slightly
toward the plotter.
(5) Mount the FPC cable bracket to the Y slider.
(6) As shown in Fig.4-78, attach double-sided tape to the Y bar at two points for securing the Y FPC
cable.
• Tape dimensions: 10 mm by 20 mm each
(7) As shown in Fig.4-79, slide the Y slider against the left mechanical stopper and then secure the Y
FPC cable at the position where it is naturally extended.
(8) Connect the Y FPC cable to the PR216012 relay board's J201 connector.
(9) Manually slide the Y slider from side to side to check that the Y slider moves smoothly and that the Y
FPC cable does not come loose.
(10) Attach the top cover and right side cover.
Fig. 4-77
Fig. 4-78
Fig. 4-79
4 - 34
FC3100-60 Service Manual
P/N53802-031T Rev. A