GRAPHTEC CUTTING PRO FC3100-60 Service Manual page 108

5.11 Overall Adjustments
Note : • After all mechanical and electrical adjustments are completed, use the gain adjustment
program to check the main axes servos and for fine adjustment of the X and Y motor offsets.
• Set the CONDITION PRIORITY function described in Section 2.6, "Using the Special
Functions," to PROGRAM.
• Set the programmable resolution to 0.100 mm.
(1) Connect the plotter to the computer via an RS-232C interface cable, making sure that the cable is
connected properly.
(2) Revise the gain adjustment program for the FC3100-60 as follows.
SPG
Traveling distance
SS, AA
(3) After inserting the floppy disk in the computer's disk drive, load and run the program.
(4) When the program is booted, the wave-form shown below appears on the computer's monitor.
FC2100-60A
5
300 x 300
60, 30
5 - 12
FC3100-60 Service Manual
P/N53802-031T Rev. A
FC3100-60
5
300 x 300
60, 30