Replacing And Adjusting The Pen Block - GRAPHTEC CUTTING PRO FC3100-60 Service Manual

4.2.8 Replacing and Adjusting the Pen Block

Replacing the Pen Block
(1) Remove the top cover (see Subsection 4.1.3).
(2) Remove the pen block cover as shown in Fig.4-50.
• Two M2 x L8 bind-head screws
(3) Remove the FPC cable guide as shown in Fig.5-51.
• Two M2 x L4 bind-head screws
* The screw may become stuck to the MC coil.
* Be careful not to scratch the slide shaft.
(4) Disconnect the pen block FPC cable from the PR216013 pen board's J32 connector.
(5) Remove the pen block as shown in Fig.4-52.
• Make sure not to damage the pen block FPC cable.
• Two M3 x L6 bind-head screws
Fig. 4-50
Fig. 4-51
Fig. 4-52
4 - 22
FC3100-60 Service Manual
P/N53802-031T Rev. A