GRAPHTEC CUTTING PRO FC3100-60 Service Manual page 12

TEST key
ORIGIN Key
COPY Key
CONDITION Key
NEXT Key
Runs a cutting test to check whether the currently selected cutting
conditions are compatible with the medium loaded.
Used to move the origin point.
To reset the plotter, concurrently press the [ ENTER ] and [ ORIGIN ] keys.
Used to repeat the cutting operation defined by the data in the plotter's
receive buffer.
Used to set the four groups of cutting conditions retained in the plotter's
internal memory or to select one group as the current cutting conditions.
To set a function at the control panel, press the [ PAUSE ] key to select
PAUSE mode and then consecutively press the [ NEXT ] key until the
desired menu appears (see Section 2.2, "Selecting a Function Menu").
2 - 2
FC3100-60 Service Manual
P/N53802-031T Rev. A