Adjusting The Y Slider Assembly - GRAPHTEC CUTTING PRO FC3100-60 Service Manual

4.2.6 Adjusting the Y Slider Assembly

Adjusting the Y Slider Roller Pressure
(1) Remove the top cover (see Subsection 4.1.3).
(2) As shown in Figs.4-35 and 4-36, disconnect the Y FPC cable and pen block FPC cable from the
PR216013 pen board.
* Take care not to damage the cables.
(3) Remove the pen board (see Subsection 4.2.2).
• Two M3 x L6 bind-head screws
(4) As shown in Fig.4-37, reduce the pressure applied by the rollers at the front of the Y slider.
• M3 x L6 bind-head screw
Fig. 4-35
Fig. 4-37
4 - 16
FC3100-60 Service Manual
P/N53802-031T Rev. A
Fig. 4-36