Factory Preset Settings - GRAPHTEC CUTTING PRO FC3100-60 Service Manual

5.13 Factory Preset Settings

Perform the following procedure after completing all of the previous adjustments.
(1) While holding down the control panel's [ ⇑ ] POSITION key, turn on the plotter.
(2) After the following messages appear on the LCD panel, turn off the plotter.
(3) After turning the plotter back on and waiting until it has been initialized, check that the plotter's
conditions are set as follows.
CONDITION 1
CONDITION 2
CONDITION 3
↓
Several moments later
5 - 16
FC3100-60 Service Manual
P/N53802-031T Rev. A