GRAPHTEC CUTTING PRO FC3100-60 Service Manual page 53

(5) As shown in Fig.4-38, reduce the pressure applied by the rollers at the rear of the Y slider.
• Two M3 x L6 bind-head screws and two tooth lock washers
* Note that the BB mounting plate may be stuck to the Y slider by adhesive used to secure the screws.
(6) As shown in Fig.4-39, secure the BB mounting plate.
* Apply pressure to the three rollers at the rear of the Y slider.
• Two M3 x L6 bind-head screws
(7) Secure the BB holder plates.
* Ensure that the BB holder plate do not contact the areas shown in Fig.4-40.
• Two M3 x L6 bind-head screws
• Apply pressure to the two rollers at the front of the Y slider.
Fig. 4-38
Fig. 4-39
Fig. 4-40
4 - 17
FC3100-60 Service Manual
P/N53802-031T Rev. A