GRAPHTEC CUTTING PRO FC3100-60 Service Manual page 44

(6) As shown in Fig.4-18, remove the two B belt stays from the top of the Y slider belt.
• Four M3 x L6 pan-head with flat washer screws
(7) Remove the Y slider belt as shown in Fig.4-19.
* Be careful not to drop the Y tension pulley as it may become damaged.
(8) To attach the Y slider belt, reverse the preceding procedure.
* Before securing the ends of the Y slider belt, loosen the M4 x L15 socket-head cap screw to the
maximum.
* As shown in Fig.4-20, ensure that the belt's notched surface fits into the Y slide's slits.
Fig. 4-18
Fig. 4-19
Fig. 4-20
4 - 8
FC3100-60 Service Manual
P/N53802-031T Rev. A