GRAPHTEC CUTTING PRO FC3100-60 Service Manual page 86

(3) Repeat the process to install the Left Side Vertical Support.
(4) Invert Assembly.
(5) Invert the Right Side Base and attach to the Right Side Vertical Support using 3 M6 x 8mm screws
and the Hex Key.
Repeat the process to attach the Left Side Vertical Base.
(6) If the Stand Assembly is skewed, loosen the supports screws. Make sure the stand is fiat.
Fig. 4-111
Fig. 4-112
4 - 50
FC3100-60 Service Manual
P/N53802-031T Rev. A