GRAPHTEC CUTTING PRO FC3100-60 Service Manual page 42

(4) As shown in Fig.4-13, remove the 60A FPC cable holder.
• Two M2 x L4 bind-head screws
(5) As shown in Fig.4-14, disconnect the pen block FPC cable from the PR216013 pen board's J32
connector.
(6) Remove the pen board as shown in Fig.4-15.
• Two M3 x L6 pan-head with flat washer screws
(7) To mount the pen board, reverse the preceding procedure.
* Avoid hitting the Y sensor plate with the pen board.
* Run the sensor test (see Section 5.14).
Fig. 4-13
Fig. 4-14
Fig. 4-15
4 - 6
FC3100-60 Service Manual
P/N53802-031T Rev. A