Test Modes For Production Inspection - GRAPHTEC CUTTING PRO FC3100-60 Service Manual

5.17 Test Modes for Production Inspection

Printing the Mechanical Check Pattern
(1) Load A1-size paper, attach a ceramic pen, and then set the CONDITION 1 parameters as follows.
(2) After pressing the [ PAUSE ] key, consecutively press the [ NEXT ] key until the menu below
appears.
(3) Press the [ 4 ] (OPTION2) key. The menu below appears.
(4) Press the [ 4 ] (TEST) key. The menu below appears.
(5) After pressing the [ 1 ] key, hold down the [ ENTER ] key as you press the [ 1 ] key again. The menu
below appears.
Press the [ 1 ] (MECHA) key to print the mechanical check pattern.
5 - 22
FC3100-60 Service Manual
P/N53802-031T Rev. A