GRAPHTEC CUTTING PRO FC3100-60 Service Manual page 83

(5) Adjust both front and rear roll guides until they are the same distance from the media bracket edge.
(6) Secure both the front and rear roll guides in place using the M4 Thumb Screw.
Adjusting the Push Roller Positions
(1) Move the push rollers as required to hold down the film within the appropriate range.
(2) Be sure to position the push rollers so they are not located right at the edges of the film or grit rollers.
Note : If necessary, slowly move the pen carriage out of the way. The pen carriage cannot be moved to
the right of the right push roller (as viewed from the front of the plotter.)
Caution : Be sure to move the pen carriage slowly. Moving the pen carriage quickly may damage the
plotter.
When "MAINTENANCE3" function has been set "ON", the pen carriage will not be released
even if the film set lever is lowered.
Fig. 4-105
Fig. 4-106
4 - 47
FC3100-60 Service Manual
P/N53802-031T Rev. A