GRAPHTEC CUTTING PRO FC3100-60 Service Manual page 56

Adjusting the Push Force
(1) Remove the top cover (see Subsection 4.1.3).
(2) As shown in Fig.4-45, attach the stainless steel plate jig (part no. 462500002).
• Ensure that the push roller is above the grit roller.
(3) As shown in Fig.4-46, push downward on the push roller arm using a 5 kgf push-pull gauge.
* Structurally, pressure cannot be applied straight down; it must be applied at a slight angle.
(4) Read the F (push force) value when the stainless steel plate jig begins to slide.
* F = 2.5 to 2.7 kgf
Fig. 4-45
Fig. 4-46
Fig. 4-47
4 - 20
FC3100-60 Service Manual
P/N53802-031T Rev. A