Replacing The Y Motor And Y Motor Pulley - GRAPHTEC CUTTING PRO FC3100-60 Service Manual

4.2.10 Replacing the Y Motor and Y Motor Pulley

Replacing the Y Motor
(1) Perform Steps (1) through (4) of "Replacing the Y Drive Belt" in Subsection 4.2.4.
(2) Remove the Y motor as shown in Fig.4-64.
* Be careful not to damage the Y motor pulley.
* Four M3 x L8 pan-head with flat washer screws
(3) To mount the Y motor, reverse the above procedure with special attention to the following point.
* As shown in Fig.4-65, mount the motor so that its leads emerge from the top of the motor.
(6) Adjust the Y drive belt's tension (see Subsection 4.2.4).
Fig. 4-64
Fig. 4-65
4 - 28
FC3100-60 Service Manual
P/N53802-031T Rev. A