5.5 Clearing the Non-Volatile RAM
Note : Be sure to clear the non-volatile RAM after replacing the main board or before starting any
electrical adjustment.
(1) After setting the SW1 DIP switch as shown below, turn on the plotter.
* Set only Bits 1, 4, and 8 to OFF
(2) The messages below consecutively appear on the LCD panel.
(3) After the "NOVRAM CLEAR END" message is displayed, return the DIP switch to its original
settings and then turn off the plotter.
Note : Clearing the non-volatile RAM initializes the pen height adjustment, distance accuracy
adjustment, and other settings to their respective default values.
(10 seconds later)
↓
5 - 5
FC3100-60 Service Manual
P/N53802-031T Rev. A