Removing The Front And Rear Guides - GRAPHTEC CUTTING PRO FC3100-60 Service Manual

4.1.2 Removing the Front and Rear Guides

(1) Remove the screws from the front and rear guides as shown in Figs.4-3 and 4-4.
• Three M3 x L6 pan-head with flat washer screws (black) each
(2) As shown in Figs.4-5 and 4-6, push the guide inward and upward to release it and then pull it off
toward you.
(3) To attach the front or rear guide, reverse the above procedure.
Fig. 4-3
Fig. 4-5
4 - 2
FC3100-60 Service Manual
P/N53802-031T Rev. A
Fig. 4-4
Fig, 4-6