Method 4 - GRAPHTEC CUTTING PRO FC3100-60 Service Manual

Method 4: Combined Execution of Methods 2 and 3
This method ultimately produces the same result as that of Method 1.
(1) While holding down the [ ⇓ ] POSITION key, turn on the plotter. (Continue holding down the [ ⇓ ]
key while the RAM is being checked.)
(2) Consecutively press the [ NEXT ] key until one of the menus below appears.
(3) After displaying each MAINTENANCE menu, press the [ 2 ] (ON) key so that the flashing cursor
moves to the ON position, then press the [ ENTER ] key.
(4) Turn the plotter off then back on again.
(5) After the RAM check, the menu below appears.
No matter which mode you select, all paper size detection is disabled.
(6) When the plotter is turned back on, the pen position becomes the origin (0.0) and the menu below
appears.
(7) Set the plot area.
Caution : Unless the plot area is set, the cutting mat may be damaged and a position error may be
caused by the pen block striking the side plate.
6 - 3
FC3100-60 Service Manual
P/N53802-031T Rev. A