The Film Stocker; Overview; Assembling The Accuload Tm Film Stocker - GRAPHTEC CUTTING PRO FC3100-60 Service Manual

FC3100-60 Service Manual
P/N53802-031T Rev. A
TM
4.4 The Accuload Film Stocker

4.4.1 Overview

This film stocker assembly was designed to improve media tracking for long length cutting on your new
plotter; see your user's manual for further details.
For best results with your plotter in long length cutting, please follow all instructions carefully and
assemble the Film Stocker to your GRAPHTEC FC3100-60 Cutting Plotter on a large, flat surface.
TM
4.4.2 Assembling the Accuload Film Stocker
Turn Off The Power
(1) Turn off the power supply to the cutting Plotter. Remove the cutter pen from the pen holder.
Attach the Left Bracket
Place the Film Stocker on a large, flat surface.
(1) Temporarily attach the first 1/2 inch Rod to the Left Bracket using a M4 x 10mm Flat Head Screw.
(2) Temporarily attach the second 1/2 inch Rod using the same hardware.
(3) Temporarily attach the 3/4 inch Rod using the same hardware.
Fig. 4-98
Attach the Right Bracket
(1) Slide a Roll Guide on the 3/4 inch Rod from the right side.
(2) Temporarily secure the roll guide in place using an M4 Thumb Screw.
(3) Temporarily attach the first 1/2 inch Rod using an M4 x 10mm Flat Head Screw.
(4) Temporarily attach the second 1/2 inch Rod using the same hardware.
4 - 43