Listing The Cutting Conditions - GRAPHTEC CUTTING PRO FC3100-60 Service Manual

2.5 Listing the Cutting Conditions

The CONDITI0N function lets you print a list of the settings of the four groups of cutting conditions, so
you can check all of your current settings at a glance.
Warning : The pen starts moving as soon as the CONDITION function is selected by pressing the [ 2 ]
key.
To avoid injury to yourself and damage to the plotter, keep your hands, face, and other
obstacles out of the vicinity of the cutting mat and paper.
Procedure
Replace the cutter pen at the pen carriage's pen holder with a plotter pen and load paper in the plotter.
[ PAUSE ] : Press the [ PAUSE ] key to select PAUSE mode.
↓
[ NEXT ] : Press the [ NEXT ] key.
↓
[ NEXT ] : Press the [ NEXT ] key again.
↓
[ NEXT ] : Press the [ NEXT ] key again.
↓
[ 4 ] : Press the [ 4 ] key to select OPTION 2.
↓
[ 4 ] : Press the [ 4 ] key to select TEST.
↓
The sub-menu below appears, so select the CONDITION function.
As soon as the [ 2 ] key (CONDITION) is pressed, the message below appears and the plotter begins
printing a list of the currently set cutting conditions.
↓
↓
When all of the conditions have been printed, the READY message reappears.
2 - 7
FC3100-60 Service Manual
P/N53802-031T Rev. A