Replacing The Adjusting The X Drive Belt - GRAPHTEC CUTTING PRO FC3100-60 Service Manual

4.2.5 Replacing and Adjusting the X Drive Belt (120TN15-10.0W)
Replacing the X Drive Belt
(1) Remove the left side cover (see Subsection 4.1.1).
(2) As shown in Fig.4-32, loosen the tension of the X drive belt.
• Four M3 x L8 pan-head with flat washer screws
* Structurally, the screwdriver contacts the chassis and drive belt.
(3) Remove the X drive belt as shown in Fig.4-33.
(4) To attach the X drive belt, reverse the above procedure.
Fig. 4-32
Fig. 4-33
4 - 14
FC3100-60 Service Manual
P/N53802-031T Rev. A