GRAPHTEC CUTTING PRO FC3100-60 Service Manual page 21

FC3100-60 Service Manual
P/N53802-031T Rev. A
Procedure
While holding down the [ ⇓ ] key, turn on the plotter.
The special functions are displayed in the sequence shown below.
TM
In GP-GL command mode In HP-GL command mode
To change the setting of the displayed menu, press the [ 2 ] or [ 4 ] key.
To register the selected setting and proceed to the next menu, press the [ ENTER ] key.
To proceed to the next menu without changing the setting, press the [ NEXT ] key.
When you have finished setting all of the special functions, turn off the plotter.
Note : Your settings are registered in the plotter's internal memory and retained even while the plotter is
turned off.
2 - 11