Replacing The Lcd Panel - GRAPHTEC CUTTING PRO FC3100-60 Service Manual

4.2.16 Replacing the LCD Panel

(1) As shown in Fig.4-83, remove the control panel base (see Subsection 4.1.4).
* Be careful not to damage the FPC cables.
• Five M3 x L6 bind-head screws
(2) Remove the LCD panel as shown in Fig.4-84.
• Four snap-in rivets (0.122" dia, black) and four flat washer (M3, paper)
* The rivets can easily be removed using tweezers.
* Be careful not to damage the board's printed circuit.
* Note that a portion of the LCD panel is attached to the double-sided tape of the control panel sheet.
Remove the tape as shown in Fig.4-85.
(3) To mount the LCD panel, reverse the above procedure.
Fig. 4-83
Fig. 4-84
Fig. 4-85
4 - 36
FC3100-60 Service Manual
P/N53802-031T Rev. A