GRAPHTEC CUTTING PRO FC3100-60 Service Manual page 89

(3) To prevent skewing the Film Stocker Assembly during final assembly, tighten the screws in the
following order:
1. Tighten the Front Right screws.
2. Tighten the Front Left screws.
3. Tighten the Middle Right screws.
4. Tighten the Middle Left screws.
5. Tighten the Rear Right screws.
6. Tighten the Rear Left screws.
TM
Install the Accuload Film Stocker Bracket
TM
Install the Accuload Film Stocker Bracket on the Stand Assembly.
(1) Lock the casters on the stand.
The front of the machine has the locking casters. Push down to lock.
(2) Make sure the front of the Film Stocker Bracket is aligned correctly.
(3) Mount the Film Stocker Bracket to the mounting flanges. Align the outside holes in the Stand flange
with the outside holes in the Film Stocker Bracket.
(4) Install 4 M4 x 8mm Screws in the outside holes using the Phillips head screw driver.
(5) Slide the platter onto the Film Stocker Brackets. Screw the Film Stocker Bracket to the plotter.
Fig. 4-119
Fig. 4-120
Fig. 4-121
4 - 53
FC3100-60 Service Manual
P/N53802-031T Rev. A