GRAPHTEC CUTTING PRO FC3100-60 Service Manual page 111

(4) Measure distances A and B of the distance accuracy pattern, and then input corrective values at the
control panel. In this example, we will input + 1.9 for the X distance and - 0.5 for the Y distance.
Use the [ 1 ] or [ 3 ] key to shift the cursor to the desired digit, then use the [ 2 ] and [ 4 ] keys to
input the numeric value.
(5) After inputting appropriate corrective values for both the X and Y distances, press the [ ENTER ] key.
The messages below consecutively appear.
(6) To adjust the distance accuracy again, press the [ ENTER ] key and repeat steps (3) and (4).
(7) When adjustment is completed, return the DIP switch to its default settings and then turn off the
plotter.
↓
The newly registered corrective values are displayed in 0.1
mm units.
5 - 15
FC3100-60 Service Manual
P/N53802-031T Rev. A