GRAPHTEC CUTTING PRO FC3100-60 Service Manual page 80

(5) Temporarily attach the 3/4 inch Rod using the same hardware.
Placing the Plotter on the Film Stocker
Note : If your plotter Is to be mounted to a GRAPHTEC plotter stand, attach the film stocker assembly to
the plotter stand before placing the plotter on the Film Stocker. The hardware required and
assembly instructions will be included in the stand accessory shipping carton.
(1) Slide the front of the plotter on to the top flanges of the film stocker brackets.
(2) Align the chassis mounting brackets on the bottom of the plotter with the flanges on the film stocker
brackets.
(3) Slide the plotter forward.
Assembly Tip : If the chassis mounting brackets bind against the sides of the film stocker brackets try the
following suggestion :
1. Turn the plotter up on its front face on a flat surface.
2. Slightly loosen the screws that mount the slide brackets to the bottom chassis.
3. Move the slide brackets inward as much as possible.
4. Tighten the screws that mount the slide brackets to the bottom chassis.
5. Turn the plotter right side up.
Now the plotter should slide onto the film stocker assembly.
Fig. 4-99
Fig. 4-100
4 - 44
FC3100-60 Service Manual
P/N53802-031T Rev. A