Replacing The Control Panel Sheet - GRAPHTEC CUTTING PRO FC3100-60 Service Manual

4.2.17 Replacing the Control Panel Sheet

(1) Remove the control panel base (see Subsection 4.1.4).
(2) Pull off the control panel sheet as shown in Fig.4-86.
(3) Use alcohol to remove any adhesive remaining on the control panel base.
(4) To attach the control panel sheet, reverse the above procedure.
* Position the sheet beginning with its bottom edge (the edge closest to you).
* Visually check that the same margin has been provided at both sides of the sheet.
Fig. 4-86
Fig. 4-87
4 - 37
FC3100-60 Service Manual
P/N53802-031T Rev. A