Replacing And Adjusting The Y Drive Belt - GRAPHTEC CUTTING PRO FC3100-60 Service Manual

4.2.4 Replacing and Adjusting the Y Drive Belt (120TN15-10.0W)
Replacing the Y Drive Belt
(1) Remove the right side cover (see Subsection 4.1.1).
(2) Remove the top cover (see Subsection 4.1.3).
(3) Remove the PR216012 relay board (see Subsection 4.2.2).
(4) Remove the Y slider belt (see Subsection 4.2.3).
(5) Remove the Y motor as shown in Fig.4-28.
• Four M3 x L8 pan-head with flat washer screws
(6) As shown in Fig.4-29, remove both the Y drive pulley and Y drive belt.
(7) To attach the Y drive belt, reverse the above procedure.
Fig. 4-28
Fig. 4-29
4 - 12
FC3100-60 Service Manual
P/N53802-031T Rev. A