Subaru Legacy 2002 Service Manual page 439

Cooling
12) Install under cover.
13) Lower the vehicle.
14) Connect battery ground cable.
15) Fill coolant. <Ref. to CO-13, FILLING OF
ENGINE COOLANT, REPLACEMENT, Engine
Coolant.>
16) Check ATF level. <Ref. to AT-9, INSPECTION,
Automatic Transmission Fluid.>
RADIATOR
C: INSPECTION
1) Remove radiator cap, top off radiator, and
attach tester to radiator in place of cap.
B2M2920
2) Apply a pressure of 157 kPa (1.6 kg/cm
psi) to radiator to check if:
(1) Engine coolant leaks at/around radiator.
(2) Engine coolant leaks at/around hoses or
connections.
CAUTION:
¼ Engine should be off.
¼ Wipe engine coolant from check points in
advance.
¼ Be careful to prevent engine coolant from
G6M0095
spurting out when removing tester.
¼ Be careful also not to deform filler neck of
radiator when installing or removing tester.
CO-24
S176058A10
B2M3127
2
, 23