Subaru Legacy 2002 Service Manual page 511

Hide thumbs Also See for Legacy 2002:
Table of Contents

Advertisement

Starting/Charging Systems
2) Remove the four through-bolts. Then insert the
tip of a flat-head screwdriver into the gap between
the stator core and front bracket. Pry then apart to
disassemble.
(A)
Screwdriver
3) Hold rotor with a vise and remove pulley nut.
CAUTION:
When holding rotor with vise, insert aluminum
plates or wood pieces on the contact surfaces
of the vise to protect rotor from damage.
(A)
Front cover
(B)
Pulley
(C)
Nut
(D)
Rotor
GENERATOR
4) Unsolder connection between rectifier and sta-
tor coil to remove stator coil.
CAUTION:
Finish the work rapidly (less than three sec-
onds) because the rectifier cannot withstand
heat very well.
G6M0065A
5) Remove screws which secure IC regulator to
rear cover, and unsolder connection between IC
regulator and rectifier to remove IC regulator.
G6M0066
6) Remove the brushes by unsoldering at the pig-
tails.
H6M0498B
SC-14
G6M0068
G6M0069
G6M0070

Advertisement

Table of Contents
loading

Table of Contents