Sensors & Software pulseEKKO Product Manual page 87

The options for this screen are explained below:
o Wi-Fi – Press this button to toggle between turning the Wi-Fi on or off. The current
status is displayed beneath the word Wi-Fi. If set to off, then the other remaining options
will be greyed out. Setting this to off and then on again will reset the Wi-Fi and it will
begin to search for available networks.
o Connect – Select the desired network and press Connect. If the connection is
successful (this can take a minute or so) a screen appears asking for the password for
that network. If the network name is yellow (from a previous connection to this network),
it will not ask for a password because it is a remembered network. Once the DVL
connects to the desired network, the Network Name will turn green.
o Forget – Use the Forget button to remove connected or remembered networks (text in
green or yellow). Once the 'forget' button is pressed on a selected network it will remove
the password and the Network Name will turn white. You will also be disconnected if you
are currently connected to that network.
o Scan – Scans for any available networks in the area and displays them in order of
strength of signal. You may need to press this button a second time if you don't see the
network you are looking for.
o Details – Press this button to display the security settings and device addresses related
to the selected network.
o Back – Press this button to return to the System Settings screen.
5.1.9 Email
Press Email Setup to enter the sub-menu where you can setup and configure a sending email
address. This is the sending account where messages will originate from. All mini-reports
received by the recipient will appear to come from this account. Ensure that this email address
already exists. You can only save email settings if you are connected to a Wi-Fi network or
hotspot on a mobile device.
Using GMAIL
The system is already pre-configured to use GMAIL as the email provider for the sending
account (Figure 5-10):
75
Tools and Preferences