Sensors & Software pulseEKKO Product Manual page 54

3.4.3 Attaching the Ball Hitch Receiver
The Ball Hitch Receiver is shipped detached from the handle assembly.
1. Determine whether to use the handle in high or low position.
2. Find the appropriate side of the handle arm to attach the Ball Hitch Receiver to.
3. Align the two white blocks with the handle arm bolt holes.
4. Place the Ball Hitch Receiver on top, lining up the holes.
5. Insert the bolts, with washers.
6. Tighten the bolts with a 7/16-inch wrench.
42
Assembling Full Configurations