Veichi AC100-T3-1R5G Manual page 149

AC100 HIGH-PERFORMANCE VC INVERTER MANUAL
0：ModBus communication: general ModBus method
1：Serial port monitoring: monitoring inverter running state by upper computer.
2：Reserved
Fd.11 CAN communication protocol selection
CAN communication protocol：select CAN communication protocol；
0：CANopen protocol: select CANopen protocol, see CANopen extended card.
1：CAN self-defined protocol: select CAN self defined protocol for network of VEICHI inverters
2：CAN Oscilloscope protocol: use this protocol when using CAN interface Oscilloscope
Tip: When [Fd.0A] = 1 or [Fd.11] = 2, normal operations can be achieved by corresponding PC software
provided by required manufacturers.
CAN communication slave machine
Fd.12
address
Set CAN communication as the slave machine address
Fd.13 CAN main machine sending selection
When setting the inverter as the CAN self defined communication host sending data to the slave machine, all slaves will
receive the command from the host when the host drive sends broadcast commands.
The host can send four polling data, corresponding to the settings of LED "0" digit, "00" digit, "000" digit and "0000" digit.
No data is transmitted when invalid.
LED "0" digit: 1st group of frame selection
0: invalid
1: run order given
2: main machine given frequency
3: main machine output frequency
4: main machine max frequency
5: main machine set torque
6: main machine output torque
7: torque mode FWD speed control
8: torque mode REV speed control
9: main machine given PID
A: main machine feedback PID
B: voltage frequency separate voltage order given
LED "00" digit: 2nd group of frame selection
LED "000" digit: 3rd group of frame selection
LED "0000" digit: 4th group of frame selection
Setting range：0-2
Setting range：0-127
Setting range：0000-AAAA
as above
as above
as above
146
FUNCTION PARAMETER SPECIFICATION
Factory default：0
Factory default：1
Factory default：0031