Veichi AC100-T3-1R5G Manual page 142

AC100 HIGH-PERFORMANCE VC INVERTER MANUAL
multi steps terminal 4(X6)
multi steps terminal 3(X5)
multi steps terminal 2(X4)
multi steps terminal 1(X3)
FC.15 PLC running mode selections
LED "0" digit: cycle mode
0: Stop after single cycle When receiving order, inverter runs from the first step, time unit is set by [FC.15] LED "00"
digit. Running time is set by [FC.16-FC.30]. Running direction and ACC/DEC time are selected by [FC.31-FC.45]. Turn
to next speed when running time is over, run time, direction, ACC/DEC time of every step can be set separately. Inverter
outputs 0 Hz when finishing 15 steps running. If one step running time is 0, it will skip this step.
1: Continuous cycles Inverter would not stop and run at the latest speed when finished 15 steps running. Time unit is
set by [FC.15] LED "00" digit. Run time is set by [FC.16-FC.30]. Run direction and ACC/DEC time is selected by
[FC.31-FC.45].
2: Keep final value after single cycle Inverter back to 1
[FC.15] LED "00" digit. Running time is set by parameter [FC.16-FC.30]. Running direction and ACC/DEC time are
selected by [FC.31-FC.45].
K1
X1 FWD/STOP
K2
X2 REV/STOP
K3
K4
X4
K5
X5
K6
COM common terminal
Terminal connection
frequency
5X
4X
3X
2X
1X
ON
ON ON ON
REV(X3)
FWD(X3)
Setting range: 0000-2212
inverter
X3
Multistep terminal 1
Multistep terminal 2
Multistep terminal 3
X6
Multistep terminal 4
6X
7X
8X
9X
10X
11X
12X
ON
ON
ON
ON
ON ON ON
ON
MULTI STEP TIME ORDER
speed after finishing 15 steps running. Time unit is set by
st
139
FUNCTION PARAMETER SPECIFICATION
time
13X
14X
15X
ON
ON
ON ON
ON
Factory default: 0000