Adjusting The White Clip - Sony BVP-900 Series System Manual

4-6 White Adjustments

4-6-6 Adjusting the White Clip

Adjust the white clip level.
Use the menu operation block of the MSU-700A/750
for the R, G, B, and master adjustments or the RCP-
730/731 for master adjustment.
To adjust from the MSU-700A/750
Proceed as follows.
1
Press and light the PAINT button.
Paint menu 1/3 appears on the display.
2
Press 4 to flip the display to Paint menu 2/3.
3
Press [White Clip] to set it in inverse video.
The lower half of the display becomes the White
Clip adjustment display.
4
Adjust the white clip level with the control knob.
To independently adjust R, G, and B: Use the
left three control knobs.
To adjust R, G, and B in combination: Use the
right-most (Master) control knob.
To turn off the white clip function
Press [White Clip Off] to set it in inverse video. The
white clip function is turned off to permit a
comparison with the white clip ON status.
Note that, however, even if the white clip function is
turned off, this system will not output a signal which
exceeds 109%.
4-54
Chapter 4 Adjustments
Paint menu 1/3
MODE
Clear
V Mod Skin SAT/
Detail
Saw Detail Contrast
Gamma
Black White Flare
/Knee
MULTI
CARD
CONFIG
MAINTENANCE
FILE
1
PAINT
Paint menu 2/3 and white clip adjustment display
Clear
Knee Knee
Knee Sat
Slope
Point
Black
Gamma
Gamma
Spread
White Clip
R G
12 -1
Home
2
1
3
Example: MSU-700A
Home
White
Clip
2
3
White
Clip Off
B Master
1 -2