Sony BVP-900 Series System Manual page 72

Connecting to the CCU-700A/700AP (digital signals)
BVP-900-series video camera
Triax cable
CCU-700A/700AP
MIC REMOTE
External microphone
control equipment
External intercom
control equipment
Note
The video input connectors which have loop-through
configuration but are not used for bridge connections,
should be terminated with 75-ohm terminators.
CAMERA
CAMERA MIC OUTPUT
ANALOG INPUT
CH-1 CH-2
RET 1 REFERENCE R
RET 2 PROMPTER G
RTS
RET 3 R
RET 4
REMOTE INTERCOM/TALLY/PGM
MIC
COAX DIGITAL VIDEO
RET 1 RET 2 1
INTERCOM
SERIAL INPUT
Control console
VIDEO IN
REF IN
Waveform monitor
VIDEO IN
WF MODE
Cable with 4-pin
connectors
WF MODE
ANANLOG OUTPUT
Y WF1 VBS1 WF MODE
R-Y PIX1 VBS2
REMOTE
RCP/CNU
B-Y WF2 VBS3
CHARACTER PIX2 AUX
SYNC
⁄
AC IN
2 3
SERIAL OUTPUT
⁄AC IN
AC power cord (supplied
with the CCU-700A/700AP)
CCA cable
RCP-700-series unit
Character display monitor
VIDEO IN
a) To connect the CCU-700A/700AP to the CNU-500/700 Camera
Command Network Unit, connect to one of the connectors CCU 1
through CCU 6 on the CNU-500/700.
b) Connect one of these to the control console according to the
signal format of the control console.
c) When the BKP-7311 SDI output board is installed in the CCU-
700A/700AP, the CCU can supply an SDI signal. If the BKP-7312
is installed, the CCU can accept an SDI return video signal.
Picture monitor
AC power source
a)
PREVIEW REMOTE I/O PORT
CCU/CNU AUX
Chapter 2 Setup
2-37