Sony BVP-900 Series System Manual page 302

To operate on the BVP-900/900P
Use the DISPLAY switch, MENU SELECT knob and
switch.
Rear panel of the BVP-900/900P
R G B
POWER
2 3 4
FILTER LOCAL H-POSI V-POSI
1 5
ND
B C D WIDTH HEIGHT
A
E
CC
CENTER SAFETY
ZONE UP TALLY MIX VF DISPLAY MENU SELECT
MARKER
ON ON ON ON
ON
OFF
CANCEL ENTER
OFF OFF OFF OFF MENU
MENU SELECT switch
DISPLAY switch
Operating procedure
1
While holding the MENU SELECT switch toward
ENTER, set the DISPLAY switch to MENU.
The Maintenance menu appears.
Maintenance menu
* Maintenance Menu *
System Setup
Reference Store
Lens File Store
OHB File Store
Auto Iris Setup
RPN Correct
29F040-BVP-900 X.XX X
menu sel --> enter
2
Turn the MENU SELECT knob to set the cursor to
"Lens File Store," then press the MENU SELECT
switch toward ENTER.
The Lens File Setup menu appears.
Lens File Setup menu
* Lens File Setup *
Lens File Store
Select Current Lens
Reset All Lens
Name :J20x7.5
No:6 EX
The data in the current file are displayed.
RET RET 1
RETURN
1
SELECT
2 3
1
4
STORE
CURSOR
1 2 3 ON
VF DETAIL PinP
ON POSITION
ON CALL
OFF OFF
MENU SELECT knob
F1.4
Name: Name of the lens
No: Lens file number
EX: Lens extender value
F: Minimum f-stop
3
Operate the lens to turn off the lens extender.
4
Referring to Chapter 4, adjust the V modulation
shading, flare and white for R and B.
5
Check that the cursor is set at "Lens File Store" (if
not, turn the MENU SELECT knob to move the
cursor), then press the MENU SELECT switch
toward ENTER.
6
Return the lens extender to the ON status and
adjust the V modulation shading flare and white
for R and B.
7
Check that the cursor is set at "Lens File Store,"
then press MENU SELECT switch toward
ENTER.
The file is changed according to the values
adjusted in step 4 and 6, and the message
"Completed" is displayed.
To return the lens file to the factory settings
Turn the MENU SELECT knob to set the cursor to
"Reset All Lens," then press MENU SELECT
switch toward ENTER.
The factory settings are restored in all the lens
files.
8
When the Change operation is completed, press the
MENU SELECT switch toward CANCEL to
return to the Maintenance menu.
To release the Maintenance menu
Return the DISPLAY switch to OFF.
To operate on the BVP-700/700P upgraded with
the BKP-7090/7090P
The camera can use the same menus as those of the
BVP-900/900P while the panel configuration differs.
For the operation on the BVP-700/700P, see "7-2-8
Adjustments of the BVP-700/700P Upgraded With the BKP-
7090/7090P."
5-17
Chapter 5 File Operations