Sony BVP-900 Series System Manual page 106

7 S2961 (SDI TEST ON/OFF) switch
When this switch is set to ON, a test pattern selected
with the S2962 switch is supplied to the SERIAL
OUTPUT connector on the CCU.
Factory setting: OFF
8 S2962 (DI BAR MODE) switch
Selects a test signal output from the SERIAL
OUTPUT connector on the CCU.
Switch settings
S2962-1 S2962-2 S2962-3
OFF OFF ON
ON OFF ON
OFF ON ON
ON ON ON
— — OFF
Note
S2962-4 switch is not used.
9 S2963 (REMOTE ON/OFF) switch
Select a signal supplied from the SERIAL OUTPUT
connector when a color bar output is selected on the
CCU.
ON: Supplies a test pattern signal selected with the
S2962 switch.
OFF: Supplies an A/D converted signal of a color bar
signal output from the VA board.
Factory setting: ON
0 CN2541 (SDI ON/OFF) switch
Set to OFF to adjust the free run frequency of the SDI
output.
Factory setting: ON
!¡ S1601 (TEST ON/OFF) switch
Used to adjust an analog signal system on the AD-117
board.
Factory setting: OFF
Test signal
75% color bar signal
100% color bar signal
Black burst signal
Multi-burst signal
Worst pattern
3-25
Chapter 3 Initial Settings