Sony BVP-900 Series System Manual page 103

3-1 Internal Boards
8 STAIR STEP controls
Adjust the position of the signal displayed on a
waveform monitor in sequential mode.
LEVEL: Adjusts the interval of the displayed signals.
POSITION: Adjusts the display position on the
monitor screen.
9 BURST controls
Adjust the burst signal.
LEVEL: Adjusts the level of the burst signal.
PHASE: Adjusts the phase of the burst signal.
0 BLACK BALANCE controls
Adjust the black balance.
I: Adjusts the I signal.
Q: Adjusts the Q signal.
!¡ VBS controls
Adjust the composite video signal.
CHROMA: Adjusts the chroma signal.
Y: Adjusts the Y (luminance) signal.
!™ RV1892 control
Adjusts the phase of the camera signal.
For details, see "3-2-2 Adjusting the Phases of the Signals."
!£ RV1 control
Adjusts the black level of the Y signal sent from the
camera.
!¢ RV125 control
Adjusts the black level of the R–Y signal sent from the
camera.
!∞ RV221 control
Adjusts the black level of the B–Y signal sent from
the camera.
!§ S1102 switch
Reverses the direction of the sequential control signal
supply.
3-22
Chapter 3 Initial Settings