Initial Settings For The Control System; Specifying The Security Code - Sony BVP-900 Series System Manual

3-4 Initial Settings for the Control System

For a system using the MSU-700A/750, you will need
to set parameters for control of your system from the
MSU-700A/750 as well as the operating conditions of
the MSU-700A/750.
The MSU-700A/750 has Engineer mode, which allows
you to assign cameras to be controlled from the MSU-
700A/750 and limit the operations on the MSU-700A/
750.
To authorize specific persons to use this Engineer
mode, specify a security code in advance. Once the
security code is set, the MSU-700A/750 will enter
Engineer mode when this security code is input.

3-4-1 Specifying the Security Code

You can set, change or delete the security code for
entering Engineer mode as follows:
To set a new security code
Menu operation block (Example: MSU-700A)
Configuration Menu
MODE
Configuration Menu
CCU
Camera
MULTI
CNU MSU
1
CARD
CONFIG
MAINTENANCE
FILE
PAINT
Note
At the factory, the unit is set in a mode in which no
security code is used. To use a security code, it is
necessary to enable the use of a security code.
See "To enable/cancel the security code" (page 3-89).
1
Press to light the CONFIG button.
The Configuration Menu appears on the display.
2
Press [MSU].
The MSU Configuration Menu appears.
Adjusting
Date /
3
Press [Security].
The Security Menu display appears.
4
2
Press [Engineer Mode] to set it to inverse video.
The Security Menu items now appear.
Status
MSU Configuration
MSU MSU SW
Set
Time
Security Menu
Engineer Mode
Security Menu
Engineer Mode
Code
Change
Engineer Mode
Chapter 3 Initial Settings
Exit
Security
Exit
Exit
(Continued)
3-87