Sony BVP-900 Series System Manual page 74

Connecting to the CCU-550A/550AP (digital signals)
BVP-950/950P+CA-570/570P,
BVP-950/950P+CA-570/570P+
CA-905K/905F+BKP-9057
S
Power HAD 1000
Triax cable
CCU-550A/550AP
External microphone
control equipment
Note
The video input connectors which have loop-through
configuration but are not used for bridge connections,
should be terminated with 75-ohm terminators.
Cable with 4-pin connectors
CAMERA WF MODE
INPUT OUTPUT
CAMERA
REFERENCE Y/G VBS3 VBS1
R-Y/R WF VBS2
RET 1
B-Y/B WF MODE
RET 2
MIC OUTPUT
CH-1 CH-2
COAX
PROMPTER/RET 3
PIX
RCP/CNU
MIC REMOTE INTERCOM/TALLY/PGM REMOTE
Control console
VIDEO IN
VIDEO IN
WF MODE
SERIAL OUTPUT
AC power source
AC power cord
(supplied with the
CCU-550A/550AP)
a)
CCA cable
a) To connect the CCU-550A/550AP to the CNU-500/700 Camera
Command Network Unit, connect to one of the connectors CCU 1
through CCU 6 on the CNU-500/700.
b) Connect one of these to the control console according to the
signal format of the control console.
c) When the BKP-5972 SDI output board is installed in the CCU-
550A/550AP, the CCU can supply an SDI signal.
Picture monitor
Waveform monitor
PREVIEW REMOTE I/O PORT
CCU/CNU AUX
RCP-700-series unit
Chapter 2 Setup
2-39