Sony BVP-900 Series System Manual page 208

Note
If you light both the WF and PIX buttons when
different signals are selected for the WF2 OUTPUT
and PIX2 OUTPUT connectors or WF OUTPUT and
PIX OUTPUT connectors, the output select buttons
corresponding to the signals selected for either of the
connectors flash.
Press the button for the signal to be output to select it
again.
For example, when you light both the WF and PIX
buttons with R + B selected for PIX2 OUTPUT and B
+ G selected for WF2 OUTPUT, the R and G buttons
will start flashing, while the B button will remain lit.
To output R and G, press the R and G buttons. Each
pressed button stops flashing and lights.
To select from the RCP-740/741
The output signal from the PIX1 OUTPUT connectors
and WF1 OUTPUT connectors of the CCU-700A/
700AP can be selected by pressing the MONITOR
SELECT buttons of the RCP-740/741.
Selection of signals from the PIX OUTPUT and WF
OUTPUT connectors of the CCU-550A/550AP is
enabled with the internal switch on the AT board.
For switch settings on the AT board, see "3-1-7 Internal
Boards of the CCU-550A/550AP."
R G B
MONITOR SELECT
The signal corresponding to the lit button is output.
R/G/B: Select the R signal, G signal, or B signal. The
signals can be selected either independently or in
combination. The same signal(s) is/are output from
the PIX1 (or PIX) and WF1 (or WF) OUTPUT
connectors. When you press any of these buttons,
the SEQ and ENC circuits are turned off.
SEQ (sequential): When you press this button, the
R/G/B circuits for the WF1 (or WF) OUTPUT are
turned off and the SEQ signal is output from the
WF1 (or WF) OUTPUT connector. You can
monitor the waveforms of the R, G, and B signals
in sequence on a monitor connected to the WF1 (or
WF) OUTPUT connector. The PIX1 (or PIX)
OUTPUT connector continues outputting the same
signal as before this button was pressed. The
waveform monitor control signal is supplied from
the CCU.
SEQ ENC
ENC (encode): When you press this button, the R/G/
B and SEQ circuits both for the WF1 (or WF) and
PIX1 (or PIX) OUTPUTs are turned off and the
ENC signal is output from both the WF1 (or WF)
and PIX1 (or PIX) OUTPUT connectors.
To select from the RCP-730/731
The MONITOR SELECT buttons of the RCP-730/731
have effect only on the WF1 OUTPUT connector of
the CCU-700A/700AP.
Selection of signals from the WF OUTPUT connector
of the CCU-550A/550AP is enabled with the internal
switch on the AT board.
For switch settings on the AT board, see "3-1-7 Internal
Boards of the CCU-550A/550AP."
SEQ ENC
MONITOR SELECT
The signal corresponding to the lit button is output.
SEQ (sequential): When you press this button, the R/
G/B circuits for the WF1 (or WF) OUTPUT are
turned off and the SEQ signal is output from the
WF1 (or WF) OUTPUT connector. You can
monitor the waveforms of the R, G, and B signals
in sequence on a monitor connected to the WF1 (or
WF) OUTPUT connector.
ENC (encode): When you press this button, the R/G/
B and SEQ circuits for the WF1 (or WF) OUTPUT
are turned off and the ENC signal is output from
the WF1 (or WF) OUTPUT connector.
4-29
Chapter 4 Adjustments