Adjustment With The Vf Setup 3 Menu - Sony BVP-900 Series System Manual

7-3 Adjustments on the BVP-950/950P
7-3-5 Adjustment With the VF
Setup 3 Menu
By pressing the MENU SELECT switch toward
ENTER with the cursor set at "Setup 3" on the
Operation menu (page 7-11), the VF Setup 3 menu
appears.
VF Setup 3 menu
* VF Setup 3 *
Mix VF
VF Detail
VF Detail Level : 0FF
VF Y Fix
Test Out Select : REM
Monitor Select
"Test Out Select" is for for stand-alone operation, and
appears only when the RM-B150, RCP-700-series
panel or MSU-700A/750 is connected to the REMOTE
connector of the camera with the CCU-700A/700AP/
550A/550AP not connected.
"Monitor Select" appears when "Test Out Select" is
set to REM,
Using these menu items, you can select control mode
and signal for monitor output from the TEST OUT
connector of the camera.
To set control mode for the TEST OUT
signal
Adjustment procedure
1
Set the cursor to "Test Out Select" by turning the
MIC 1 LEVEL control.
The REM or LOC indication starts blinking.
2
Press the MIC 1 LEVEL control.
Each time you press the control, "REM" and
"LOC" are cyclically selected.
When the item is set to "LOC (local)," the TEST
OUT signal can be selected using the TEST OUT
selector in the side switch box of the camera.
When the item is set to "REM (remote)," the
signal select buttons of the camera are disabled.
7-12
Chapter 7 Stand-Alone Operations of Cameras, etc.
: 0FF
: 0FF
: o
: Y
The TEST OUT signal currently selected is
displayed for "Monitor Select."
The signal can be selected using the MONITOR
SELECT button on the connected MSU-700A/750
or the RCP-700-series panel or on the Monitor
Select menu.
To select the TEST OUT signal with the
Monitor select menu
1
Set the cursor to "Monitor Select" by turning the
MIC 1 LEVEL control.
The singal indication starts blinking.
2
Press the MIC 1 LEVEL control.
Each time you press the control, "Y," "R," "G," and
"B" are cyclically selected.
When the selection is completed
Press the ENTER/CANCEL switch toward CANCEL
to return to the Operation menu.