Mounting The Bvp-900/900P - Sony BVP-900 Series System Manual

2-1 Mounting the Video Camera

2-1-1 Mounting the BVP-900/900P

Mounting the CCD unit
The BVP-900/900P is used in conjunction with one of
four different CCD units (OHB-730/730P, OHB-
730WS/730WSP, OHB-750A/750AP or OHB-
750WSA/750WSAP), depending on the purpose.
Proceed as follows.
1
Remove the red connector cover from the rear of
the CCD unit.
2
Loosen the lens-lock knob, turn the lens lock
counterclockwise, and remove the front panel.
Screw A
Lense lock
3
Loosen screw A on the front, and open the
insertion-prevention plate.
4
Insert the CCD unit, and secure it with the four
mounting screws.
Fasten the screws securely with a screwdriver or
similar tool.
2-2
Chapter 2 Setup
1
3
2
Front panel
5
Turn the mounting lever on the CCD unit fully
counterclockwise, and remove the mounting cap.
6
Turn the mounting lever clockwise to its lowest
position.
7
Close the insertion-prevention plate, and secure it
with screw A.
Caution
• Be sure to mount the
CCD unit
and correctly. Otherwise it may be damaged.
•
Be sure to fully turn the mounting lever to its lowest
position. Otherwise the lens may be damaged.
•
Be sure to close the insertion-prevention plate and
fix it securely. Otherwise the lens cannot be
mounted.
4
Mounting lever
5
Mounting cap
7
6 6
to the camera securely