Internal Board Of The Vcs-700 - Sony BVP-900 Series System Manual

3-1-8 Internal Board of the VCS-700

1 POWER indicators
2 STAIR STEP controls
3 MODE switches
4 CONTROL switch
1 POWER indicators
Light when the specified power is supplied to the
VSW board.
2 STAIR STEP controls
Adjust the signal displayed on the waveform monitor
in sequential mode.
LEVEL: Adjusts the interval of the displayed signals.
POSITION: Adjusts the display position on the
monitor screen.
3 MODE switches
Use these switches for setting the system of the VCS-
700. To control the system with the MSU-700A/750
connected to the CNU-700/500, set the S4-5 switch to
OFF.
For details, consult your Sony representative.
4 CONTROL switch
When the adjustment is made on the switches and
controls on the VSW board, set the switch to PRESET.
The value set with external equipment connected to the
REMOTE connector on the rear panel is returned to
the center value of the adjustable range.
5 PIX (picture monitor input signal) 1 through 6
controls
Adjust the signal input to the PIX 1 through 6
connectors on the rear panel.
LEVEL: Adjusts the level of the input signals.
CHROMA: Adjusts the chroma level of the input
signals.
6 PIX B OUT (picture monitor B output) switch
Sets the cable compensation according to the length of
the cable used for connecting the picture monitor to the
PIX B OUTPUT connector.
POWER
I
STAIR STEP
CONTROL 1
POWER
MODE
LEVEL
-15V-5V +5V +15V POSITION PRESET LEVEL
CHROMA
O
PIX WFM
B OUT B OUT
2 3 4 5 6 1 2 3 4 5 6
FINE FINE
OFF LEVEL
LEVEL LEVEL LEVEL LEVEL LEVEL LEVEL LEVEL LEVEL LEVEL LEVEL LEVEL OFF LEVEL
CHROMA CHROMA CHROMA CHROMA CHROMA 50 100 CHROMA CHROMA CHROMA CHROMA CHROMA CHROMA CHROMA 50 100 CHROMA
!º WFM B OUT FINE controls
9 WFM B OUT switch
8 WFM 1 through 6 controls
7 PIX B OUT FINE controls
6 PIX B OUT switch
5 PIX 1 through 6 controls
50: For a cable of 50 meters (165 feet) long
OFF: For no cable compensation
100: For a cable of 100 (328 feet) meters long
7PIX B OUT (picture monitor B output) FINE
controls
Adjust the signal output from the PIX B OUTPUT
connector.
LEVEL: Adjusts the level of the output signals.
CHROMA: Adjusts the chroma level of the output
signals.
8WFM (waveform monitor input signal) 1 through
6 controls
Adjust the signal input to the WF 1 through 6
connectors on the rear panel.
LEVEL: Adjusts the level of the input signals.
CHROMA: Adjusts the chroma level of the input
signals.
9WFM B OUT (waveform monitor B output)
switch
Sets the cable compensation according to the length of
the cable used for connecting the picture monitor to the
WF B OUTPUT connector.
50: For a cable of 50 meters (165 feet) long
OFF: For no cable compensation
100: For a cable of 100 (328 feet) meters long
!ºWFM B OUT (waveform monitor B output)
FINE controls
Adjust the signal output from the WF B OUTPUT
connector.
LEVEL: Adjusts the level of the output signals.
CHROMA: Adjusts the chroma level of the output
signals.
3-35
Chapter 3 Initial Settings