Sony BVP-900 Series System Manual page 102

VA board
!™ RV1892 control
1 Power indicators
2 REMOTE/LOCAL switch
3 SC PHASE switch/control
4 H PHASE controls
5 V BLANKING switch
a) The V BLANKING switch is not available on the CCU-700AP.
1 Power indicators
Light when the specified power is supplied to the VA
board.
2 REMOTE/LOCAL switch
Selects the control mode.
REMOTE: For controlling with external equipment
connected to the RCP/CNU or AUX connector on
the rear panel.
LOCAL: For controlling with the switches and
controls on the internal boards. When the switch is
set to this position, the value set with the switches
and controls on this board is retrieved.
3 SC PHASE switch/control
Adjust the SC phase. Roughly adjust the SC phase
with the STEP switch, then execute fine adjustment
with the FINE control.
RV221
RV1892
RV1963
RV1304
RV1962
RV1303
RV1961
S1501
S1892
S1962
S1961 RV761 RV1102
RV1101
VA
STAIR
BC PHASE H PHASE
V WFM1
STEP
–12 –5 +5 +12 BLANNKING
GEN LEVEL
REMOTE LOCAL FINE COARSE FINE 19 20 21 LEVEL
STEP LOCK POSITION
H
a)
4H PHASE controls
Adjust the H phase. Roughly adjust the H phase with
the COARSE control, then execute fine adjustment
with the FINE control.
5V BLANKING switch (only on the CCU-700A)
Selects the vertical blanking line among from 19H,
20H and 21H.
6 WFM (waveform monitor) 1 control
Adjusts the level of the signal output from the
WF 1 connector on the rear panel.
7GEN LOCK indicator
Lights when the signal output from the CCU-700A/
700AP is synchronized with the reference signal input
to the REFERENCE INPUT connector on the rear
panel.
RV1
!£ RV1 control
RV125
!¢ RV125 control
!∞ RV221 control
!§ S1102 switch
RV1362
RV1363
RV1364
BLACK
BALANCE
BURST VBS
LEVEL PHASE I O CHROMA Y
!¡ VBS controls
0 BLACK BALANCE controls
9 BURST controls
8 STAIR STEP controls
7 GEN LOCK indicator
6 WFM 1 control
Chapter 3 Initial Settings
3-21