Sony BVP-900 Series System Manual page 41

2-1 Mounting the Video Camera
Attaching the 7-inch viewfinder
For details on attaching a viewfinder, refer to the
instruction manual furnished with the viewfinder.
Note
Be sure that the VF connector on the viewfinder mount
is positioned at a right angle to the control panel of the
camera.
Proceed as follows.
1
Place the viewfinder on the viewfinder mount of
the camera so that the mounting wedge on the
bottom of the viewfinder enters the V-shaped
recess on the viewfinder mount and that the
projections on the bottom of the viewfinder are
placed at the position shown in the figure above.
Projections
Bottom of the
viewfinder
1
Viewfinder
mount
VF connector
2-6
Chapter 2 Setup
Panning base
Mounting wedge
V-shaped recess
Pan-friction screw
2
Push the viewfinder by the handle so that the
panning base is securely held by the viewfinder
mount.
Pull the handle to check that the viewfinder is
fixed to the camera.
2
3
3
Turn the viewfinder counterclockwise.
Adjusting the pan-friction of the viewfinder
You can adjust the friction for panning the viewfinder
with the pan-friction screw. The friction increases as
the screw is turned clockwise, while the friction
decreases as the screw is turned counterclockwise.