Internal Boards Of The Ccu-700A/700Ap - Sony BVP-900 Series System Manual

3-1-6 Internal Boards of the CCU-700A/700AP

The functions of the switches and controls on the
internal boards of the CCU-700A/700AP are
introduced here.
DYNAMIC
CABLE
MIC
ALARM OFF
SHORT OPEN
CARBON
MAIN CAMERA
POWER POWER
INTERCAM
I I
O O
Removing the front panel
Loosen the left and right screws on the front panel, and
remove the panel as shown below.
S
1
1
2
You can remove the front panel of the CNU-700 in the
same way.
Attaching the front panel
Place the front panel as it was, and secure it with the
left and right screws.
DM
–12 –5 +5 +12
Y R-Y B-Y GND Y R-Y B-Y
AT MIC LEVEL
CCU REAR INCOM
NORM NORM
–12 –5 +5 +12 PAINT INCOM MIC SELECT
MIN MIN
CLEAR DYNAMIC CARBON ENG I PROD
CH-1 CH2
PRIVATE
VA
STAIR
BC PHASE H PHASE V WFM1
STEP
–12 –5 +5 +12 BLANNKING
GEN LEVEL
REMOTE LOCAL FINE COARSE FINE 19 20 21 LEVEL
STEP LOCK POSITION
H
C A M
E R A
C O N
T R O
L U N
IT
1
DM board
AT board
ENG PROD
PGM SIDE 2W 2W NTS 2W 2W NTS
MIX TONE LEVEL CANCEL CANCEL LEVEL CANCEL CANCEL
BLACK VA board
BALANCE
BURST VBS
LEVEL PHASE I O CHROMA Y
Optional board
(YC board/AD board)
Detaching an internal board
Remove the front panel, then push and turn the left and
right eject levers to the board. Then pull the board out
from the CCU-700A/700AP.
1
You can remove the internal board of the CNU-700 in
the same way.
Installing the board
Turn the left and right eject levers inside. Then insert
the board in the slot, and push it until it stops. Then
push the eject levers toward the side panels to lock the
inserted board.
2
1
Chapter 3 Initial Settings
3-17