Sony BVP-900 Series System Manual page 271

4-17 Y/C (Sub-Encoder Board) Adjustments (NTSC)
To adjust from the MSU-700A/750
Proceed as follows.
1
Press and light the PAINT button.
Paint menu 1/3 appears on the display.
2
Press 4 twice or $ once to flip the display to Paint
menu 3/3.
3
Press [Color Correct] of Paint menu 3/3 to set it to
inverse video.
The lower half of the display becomes the Color
Correct adjustment display.
There are six Color Correct adjustment displays for
A, B, C, D, E, and F, which can be selected on the
submenu.
To turn on/off the function on the display
Press [Color Correct] of the Color Correct
adjustment display.
4
Adjust Color Corrector A.
1) Press [A] of the submenu to set it to inverse
video.
2) Press [Correct A] to set it to inverse video.
3) Adjust the phase, width, hue, and saturation
with the corresponding control knobs.
5
Adjust Color Correctors B through F in the same
manner.
Color Corrector Gate function
When the color corrector function is on, press [Gate]
to set it to inverse video, and the area where the color
corrector function is effective will be displayed on the
picture monitor connected to the PIX1/PIX2 OUTPUT
connectors of the CCU-700A. As this gate signal is
not sent to the line output, this function can be used
even when the picture is on the air.
4-92
Chapter 4 Adjustments
Paint menu 1/3
MODE
Clear
V Mod Skin SAT/
Detail
Saw Detail Contrast
Gamma
Black White Flare
/Knee
MULTI
CARD
CONFIG
MAINTENANCE
FILE
1
PAINT
Paint menu 3/3 and Color Correct adjustment display (C)
Clear
Mono
Auto Iris
Color
Color
Matrix EDTV
Correct
Spread
Color Correct <C>
A B C D E F
Phase Width
20 10
Home
2
1
3
Example:
MSU-700A
Home
ECS
/S-EVS
3
3
Comb
Gate
Correct Color
C Correct
Hue Saturation
–3 5