Sony BVP-900 Series System Manual page 118

9CHARACTER PHASE control
For adjusting the horizontal phase of the signal output
from the CHARACTER connector.
0 S3 switch
The S3-1 switch selects the broadcast system of the
signal output from the CHARACTER connector if no
signal is input to the REFERENCE connector.
OFF: 525 line
ON: 625 line
The 3-2 to 3-8 switches are not used.
IF-689 board
IF S-BUS
S-BUS ID No.
+5 RX TX
1 2 3 4
3 S-BUS ID No. switch
2 S-BUS indicator
1 +5 V indicator for the IF board
1 +5 V indicator for the IF board
Lights when +5 V power is supplied normally to the
IF-689 board.
2S-BUS indicator
Lights to indicate the status of the S-BUS
communication.
3 S-BUS ID No. (statuion ID setting) switch
For setting the station number of the CNU-700 on the
S-BUS data link.
For details, see "3-2-6 Setting the Station ID."
4 CNU GROUP No. (group number setting) switch
For setting the group number of the CNU-700. Do not
set the same number for two or more devices in one
system.
For details, see "3-2-5 Setting the Camera Number and
Group Number."
CNU GROUP No.
4 5
3 6
2 7
5 6 7 8 1 8
4 CNU GROUP No. switch
3-37
Chapter 3 Initial Settings