Sony BVP-900 Series System Manual page 85

3-1 Internal Boards
8 S352 switch
Set the signal mode of the tracker and Intercom 2.
S352-1: Set to ON for mixing the program audio
signal onto the signal output from the TRACKER
connector.
Factory setting: OFF
1)
S352-2 : Set to ON for mixing the Intercom 2 signal
onto the signal output from the TRACKER
connector.
Factory setting: OFF
1)
S352-3 : Set to ON for mixing the signal sent from
the TRACKER connector onto the microphone
output signal of Intercom 2 sent to the CCU.
Factory setting: OFF
1)
S352-4 : Set to ON for mixing the signal sent from
the TRACKER connector onto the Intercom 2
receive output signal sent from the CCU.
Factory setting: OFF
9 S900 (RTS 1 select) switch
Select whether Intercom 1 of the BVP-900/900P is set
to the RTS system or not.
RTS: Set to the RTS intercom system
NORM: Set to the normal intercom system
Factory setting: NORM
0 S901 (RTS 2 select) switch
Select whether Intercom 2 of the BVP-900/900P is set
to the RTS system or not.
RTS: Set to the RTS intercom system
NORM: Set to the normal intercom system
Factory setting: NORM
!¡ S902 (RTS power select) switch
Select the RTS belt-pack power, RTS CH1 or RTS
CH2.
Factory setting: CH2
..........................................................................................................................................................................................................
1) Normally set S352-2, S352-3, and S352-4 switches to the
same position.
3-4
Chapter 3 Initial Settings
2)
2)
2)
!™S151 (MIX MODE 1) switch (only on the BVP-
900)
Selects a method for adjusting the signal level when a
program audio signal is mixed with the Intercom 1
audio signal of the video camera.
IND: The Intercom 1 audio level is adjusted with the
INTERCOM control, and the program audio level
is adjusted with the PGM control.
MIX: The mixed sound is adjusted with the
INTERCOM control, and the mix ratio is adjusted
with the PGM control.
Factory setting: IND
!£S150 (INTERCOM 1/PGM MIX) switch (only on
the BVP-900)
Selects whether to mix the program audio signal and
Intercom 1 signal of the video camera.
IND: The signals are not mixed.
MIX: The signals are mixed.
Factory setting: IND
!¢S152 (INTERCOM 2/PGM MIX) switch (only on
the BVP-900)
Selects whether to mix the program audio signal and
Intercom 2 signal of the video camera.
IND: The signals are not mixed.
MIX: The signals are mixed.
Factory setting: IND
!∞S153 (MIX MODE 2) switch (only on the BVP-
900)
Selects a method for adjusting the signal level when a
program audio signal is mixed with the Intercom 2
audio signal of the video camera.
IND: The Intercom 2 audio level is adjusted with the
INTERCOM control, and the program audio level
is adjusted with the PGM control.
MIX: The mixed sound is adjusted with the
INTERCOM control, and the mix ratio is adjusted
with the PGM control.
Factory setting: IND
2) Set these switches only when an optional BKP-7913 RTS
Kit is connected to the INTERCOM 2 connector.